Trikdis Cellular Communicator G16T

‘- Connects to any alarm panel which has a landline dialer.
– Transmits full event information to the security company’s monitoring station.
– Works with Protegus app. Users can arm/disarm their alarm system remotely and receive notifications about events.
– Can be ordered with 2G or 4G modem.

Connects to panel’s landline dialer:

• Communicator can be connected to control panel’s landline dialer with 2 or 4 wires.
• When connected with 4 wires, the landline between the panel and communicator will be monitored.

Sends events to monitoring station receiver:

• Sends events to TRIKDIS software or hardware receivers that work with any monitoring software.
• Can send event messages to SIA DC-09 receivers.
• Can send event messages to SUR-GARD receivers. The annex has a table for converting Contact ID codes to SIA codes.
• Connection supervision by polling to IP receiver every 30 seconds (or by user defined period).
• Backup channel, that will be used if connection with the primary channel is lost.
• Events can be reported to CMS with SMS messages. SMS will be sent even if data connection stops working in the mobile operator network.
• With parallel communication channels events can be sent to two receivers at same time.
• When Protegus service is enabled, events are first delivered to CMS, and only then are sent to app users.

Works with Protegus app:

• “Push” and special sound notifications informing about events.
• Remote system Arm/Disarm.
• Remote control of connected devices (lights, gates, ventilation systems, heating, sprinklers, etc.).
• Remote temperature monitoring (with iO or iO-WL expanders).
• Different user rights for administrator, installer and user.
• Users can also be informed about events with SMS messages and phone calls.

Notifies users:

• Users can be notified about events not only with Protegus app, but also with SMS messages and a call.

Controllable outputs and inputs:

• 1 output, controlled via:
  • Protegus
  • SMS message.
• 2 double I/O terminals that can be set either as input (IN) or controllable output (OUT) terminals
• Add additional inputs and controllable outputs with wired and wireless iO

Quick setup:

• Settings can be saved to file and quickly written to other communicators.
• Two access levels for configuring the device for CMS administrator and for installer.
• Remote configuration and firmware updates.